About adity

adity · 09-26-2024

Hi Techies, We have 2 cisco 9300 switch installed in our infra, 1 switch is use for Core activity and another is Access Switch, the routings happed on the core switch... on the Core SW have different VLANs example Vlan 50 (Subnet - 192.168.10.0/24) ...

adity · 09-25-2024

Hi Team, I am stuck in one issue i would like to all please help me to resolve this issue......I have cisco FTD 3105 model with version 7.3.1, from my firewall have configured 2 tunnels for different clients but the issue is both the clients have sa...

adity · 09-02-2024

Can we configure the same FMC at two hypervisor We have a FTD 305 manage by FMC-V... The FMC-V is configured on Nutanix hypervisor and also we have a VMware setup... Problem statement:When the Nutanix server goes offline or rebooted during that time...

adity · 08-07-2024

Hi Techies, I need your help in one of the problem, I have a FPR 1120 manage by FMC on FPR we have 3 zones.Inside Outside ---- IP : 204.42.3.3 ( configured on Outside FW WAN interface)DMZ ----- IP : 192.168.25.15 ( configured on Hst machine).I am tr...

adity · 06-12-2024

SPI Enabled or not in FTD My auditor ask the below points evidence, kindly check and pls help us1. Provide screenshot to show stateful inspection enabled on external firewalls in scope.2. Provide screenshot for anti-spoofing access list or similar se...

adity · 09-27-2024

Should I apply IN and OUT on both the VLANs.................................Could you pls help me to understand as its getting confusing now...

adity · 09-26-2024

The flow would be unidirectional I guess in cisco ACL and let say if any subnet trying to reach on 192.168.10.45 then how would comm will happen!!!

adity · 09-26-2024

It would be very helpful if you helpme with some example, I have shared the details in above my post.

adity · 09-25-2024

We dont have control on Remote firewall, 172.16.1.0/24(Virtual IP address) is natted ip, remote side they will receive the traffic from this IP original IP 10.12.10.0/24

adity · 09-02-2024

Can some anyone confirm the same, can we setup a FMC-V between 2 different hypervisor??????

Member Since	‎07-26-2022 12:51 AM
Date Last Visited	‎10-24-2024 01:37 AM
Posts	46
Total Helpful Votes Received	4

User Statistics

User Activity

Cisco 9300 Switch || restrict the inter VLAN communication

IPsec tunnel with same phase 2 IP addresses

Can we configure the same FMC at two hypervisor

Unable to telnet my WAN IP from DMZ network

SPI Enabled or not in FTD

Re: Cisco 9300 Switch || restrict the inter VLAN communication

Re: Cisco 9300 Switch || restrict the inter VLAN communication

Re: Cisco 9300 Switch || restrict the inter VLAN communication

Re: IPsec tunnel with same phase 2 IP addresses

Re: Can we configure the same FMC at two hypervisor