Hi,The EPLD is OK to support FEX. Could you double check if the SFP is supported, in case you use copper connection.http://www.cisco.com/en/US/partner/docs/switches/datacenter/hw/nexus7000/installation/guide/n7k_connect_specs.html#wp1044250Also, plea...
Hi Hiep,There are several features configured on VSS: WCCP, NAT, Netflow etc. The high cpu might be caused by flow mask confilicts. please change the flow mode to interface full.Fore more detail, please refer toTable 57-1 Feature Requirements for...
Hi Mahesh,The configuration of all member ports are not the same. You could "default interface xx" and then configure all of them with rage command to make sure they have identical configure as following,default interface int Gx/xinterface range int ...