Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everybody.I'm having 2 switches that runs the network.However, i want to create a seperate VLAN 2000 for port 48 & 52 on switch 1.The same on switch 2.Switch1 Port 52 --------------connected-------------Port52 Switch2When i do this, Port52 on S...
Hello everybody.I am facing a problem.DHCP is active on the INSIDE interface.However i get the following log messages:UDP request discarded from 192.168.1.254/67 to INSIDE:192.168.1.1/67dhcpd address 192.168.1.2-192.168.1.249 INSIDE
dhcpd dns 8.8.8.8...
Hello Cisco'ersI have the following scenario:2 ASA's in Active Standby Failover config. Connected to a switch in a VLAN10.To connect this to a Wlan Controller, do i need to set the switchport as trunk?If yes, why?Hope somebody can release me from the...
Hello everybody,something is confusing me;i red that you need only one L-ASA5510-SEC-PL for setting up a Active/Standby Failover.I installed the license on the 1st ASA and tried to setup the failover via the ASDM wizard.It always fails, because the 2...
Hello Cisco'ersI am planing to implement an ASA55100 in our network.I've never worked with an ASA5510 device, so i am not quiet sure how to place it correctly.The idea is the following:Current SituationNetwork with wireless access, everybody who's co...
Hi Julio,the only log message i see (that is related to this), is the one i posted:UDP request discarded from 192.168.1.254/67 to INSIDE:192.168.1.1/67
Hi Jouni,basically the requests commning from a wireless controller. thats why its not 0.0.0.0.If i connect a host directly to the ASA i get a DHCP. I would like to use the ASA as DHCP over the wireless controller.
Alright, but why do i get an error message then?The devices are on 8.4.And what is this sentence about-> "For the ASA 5505 and 5510 adaptive security appliances, both units require the Security Plus license; the Base license does not support failover...
