Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
1. If you add a switch to BBSM with say 24 ports and chain a 24 port hub off of switch port 1, will BBSM be ok with that? Or will it lock port 1 because of seeing 24 people on that port?2. if you add a switch to BBSM that has a management ip addre...
I tested the AP350 IOS converstion program on a BR350 by creating a config and that part worked. And I know that the firmware for the AP's and BR's and the same, so I assume I can use the utility to upgrade my BR350s. But I thought I would ask to ma...
Has anyone ever found out why on a BR350 the ethernet light will start flashing red and the unit stops passing traffic? I was hoping 12.03 would fix it, but nope. Signal strength is over 60% and usually the unit works fine at 11mb. It's not a bad u...
We've had an ongoing problem. We put in BR350's going across short distances to some university apartments (1/4 mile most, line of sight). The root unit (on the campus LAN) almost never has a problem. But the non-roots connecting to it constantly go...
Ok not getting an answer here, I opened a TAC case. They told me that IOS would be available only for the AP350 and not the BR350s. His english wasn't very good, but I was clear on the part he said about "no plans to release IOS for the bridges". ...
I know exactly what he means. If you have AP350s connected to a 4000 such that a client rapidly moves between the 350s, the 4000 will see it as a flapping client. I do not know how to avoid it, however.
FWIW, I have seen this too. But considering this is the first firmware version I've seen that doesn't constantly flap (associate/reassociate) I am gladly logging in twice rather than back revision. I am just hoping that it stops the br350's from free...
Yes, you should use one port and an omni. We made this mistake at first. The 2 ports aren't made for signal splitting, and trying to use them like that will cause you problems.
Yes!! Thank you guys! We've had our BR350's in this exact configuration and they've been going down like crazy. Our "certified" cisco reseller told us you could put 2 directional antennas on a br350 and point them different directions without any pro...
