Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Under the AP Radio: Internal hardware (802.11b) configuration, I have looked through all manuals I could find on line and help files, but still not clear about most optimal configuration for our type of setup.Stationary but heavily dispersed (distanc...
We have pieces together because of poor budget the following messy setup:[ HQ T1 ==== Cisco 1600 ==== catalyst1900 switch ==== openbsd router/firewall ====== bay 28200 switch ====== netgear me102 point to multipoint] ==wireless== [tower ==== cabletro...
On this unit, if any single user (worse if more users do the same) performs sustained "heavy" loads (1.5Mbps or higher) the ping times start climbing higher and higher, eventually staying around 700-2000 ms. If either a warm or cold restart is perfor...
Here's a specific example, I gather this information via the web interface by going to the Associations table, then click the MAC address/link of a connected client:MAC: 00:04:5a:ef:bf:70To Station:Total Bytes OK:4963928How what is the OID for that v...
AP 1200 with 12.01T.Netgear ME102 with 1.4h.4AP 1200 as Root AP.Regular clients can connect ok (though a pain with XP users, and SSID Broadcasts have to be on for XP to even work with it, big pain), but when trying to connect the ME102 in AP CLient m...
We managed to resolve this by doing a few things.A: Adjusted the sector antenna downtilt from around 5-10 degrees to only 3 degrees.B: Changed the preambles from long to short on both the AP's and the clients (compatability to performance)C: Replaced...
We had tried various speed settings, lower ones slowed it down correctly, higher ones were to no avail.Well, despite their (UUNet's techs) protestions to the contrary, it turned out to be the UUNet folks.We had temporarily given up, and just left eve...
As a WISP we're very frustrated by the Cisco -> XP combo.If SSIDs are turned off, the XP clients (especially XP Home is the worst) will find but keep losing it's association, and repeatedly have to be setup over and over, unless they leave the proper...
I don't have any trouble getting tons of snmp information, I just can't get any of the information specific to what you listed.I can do a snmpwalk or snmpget's of many, many OID but number or name, but cannot get anything for the users/clients connec...
