Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Trying to add a static route: static (inside,outside) x.x.x.x 192.168.0.2 netmask 255.255.255.0
Receiving the attached error. Is it a different syntax to add this command on the 5506X?
We now need to use TLS in Outlook 2010 for email - according to the provider we only need port 995 open. Have that open to all systems, but we get "The computer does not support the encryption type" error. Move the system outside the firewall and it...
We have a main offfice and remote office on different ISP's - both behind ASA-5510s. Main office is a 192.168.200.xxx subnet, remote office is 192.168.210.xxx. Offices were connected through a point to point vpn on the ASAs. We now have a direct laye...
We're using an ASA-5505 and have switched to a DSL line that uses an ActionTec m1000 modem. To pass the static IP block straight through to the ASA the modem needs to be in bridging mode - but when it is a straight pass-through the modem does not sen...
I have an ASA 5510 in our primary location with all inbound / outbound traffic directed through it to our primary ISP. I now have 5 systems in a remote datacenter behind a 2nd ASA 5510 and a 2nd WAN link from a 2nd ISP (the data center). I want to us...
Hi Akshay,
The Object network obj-192.168.0.2 command work fine. The firewall would not take the host 192.168.0.2 or nat (inside,outside) static x.x.x.x commands. Any suggestions?
Thank you!
Thanks - it is a DSL modem, ActionTec 1524. All I can do on it is turn NAT off. I have set port forwarding on it to pass both port 25 and 3389 to the outside address of the PIX (192.168.0.2) and set the access-list in the PIX to allow those ports to ...
