Hi,Anyone got any idea what this means?CCB:callid=80F1, sapi=0, ces=0, B-chan=31, calltype=DATA, hdlctype=HDLC-TRUNKI have configured ISDN and seem to be getting the above on my layer 3. For ref please see the output from various commands.# sh isdn s...

Hi,I have built a VPN tunnel between two routers. The tunnels work fine and get pings replies from either sides of the tunnels. The problem is that the pings are fine until you send upto 1468bytes packets over 1468 and ping replies fail.Any ideas why...

Hi,When you do a Show IP interface brief command on a router and you get STATUS reset and PROTOCOL down on a Serial0/0:0. What does the RESET mean. I have always come across either UP/UP; Down/Down or UP/Down. Never come across Reset/Down. How do I g...

Hi,I seem to be having problems pinging the directly connected router. My interfaces at both routers are UP/UP. But cannot ping the other end.When I ping from my Node to the CPE router I get U.U.U.U. and when I ping the node from the CPE I get ..... ...

Hi,I have just had a router 2610 IOS upgraded and am seeing the following message: error 0xda9544 Can not load flash.Does anyone know what the problem could be.Thank you in advanceJay