Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi to all,I need redirect a range of ports from my public IP on the WAN side to a host in my LAN, and keep the statics NATs/NATPs too. As far i know this would be no posible because Cisco IOS for 877 does not have a parameter to specify a range of po...
Hi to all.I have configured the wireless part of my router 877W. Right now i am using WEP only but i want to setup WPA (with pre shared key) for a more secure access. I am a wireless noob and i haven't much knowledge about this configuration process ...
Hi have bought a Cisco 877W router and i have a problem with it.Please, i need some help with this.My ISP is Arrakis in Spain a branch of BT. The problem is as follows:The ADSL CD light stay on, thus, there are sync with the DSLAM, but the ATM0 inter...
Hi again, guysProblem solved...What fool i was...i forgot configure the access list to open the destination ports too.access-list 101 permit tcp any host eq 3724access-list 101 permit tcp any host eq 6112access-list 101 permit tcp any host range 6...
Hello,Asuming you have a valid IOS image on flash yet. Can you try this, please?set boot-action=flashset file-name=set ios-conf=0x2102savebootGood luck
I see the problem now.Your 877w does not have a valid IOS image to boot from, thus your router does not accept any command because it have no "operating system".Your router enters in ROMmon mode and you are unable to issue any IOS command. You have t...
