About cjames235

cjames235 · 08-23-2010

I have an SGE2000 (latest firmware, 3.0.0.18, boot 2.0.0.03) on which I'm trying to configure some VLANs. After having defaulted the configuration to factory settings, I've performed the following steps:Set the operating mode to Layer 3Set the stacki...

cjames235 · 08-24-2010

Thank you for your help guys. I managed to solve it eventually.I had to change the default IP address of the SGE2000's VLAN1 to anything other than 192.168.1.254 using the console. The switch immediately starts responding to the new IP address on VLA...

cjames235 · 08-24-2010

HiYes, I have set the mode to Layer 3 and rebooted the switch. The menu structure of the web interface changes to match L3, so I know the mode change has been successful.Charlie

cjames235 · 08-23-2010

HiNo, I haven't set 1000 as the management VLAN - primarily because I do not wish to change the management VLAN from the default. All I want to do at this stage is add additional interfaces for each new VLAN to allow me to do InterVLAN routing...Than...

cjames235 · 08-23-2010

HiI have tried connecting to one of the VLAN 1000 ports and I do not get a reply from 192.168.4.254. It's as if the configuration interface just falls over as soon as the changes are submitted.Charlie

cjames235 · 08-23-2010

Hi RezaI have tried using many different VLAN numbers, from 2 to 1000, all have the same effect.Charlie

Member Since	‎08-23-2010 06:14 PM
Date Last Visited	‎08-18-2017 03:54 AM
Posts	6

User Statistics

User Activity

SGE2000 Locks up when adding IPv4 Interfaces to VLANs

Re: SGE2000 Locks up when adding IPv4 Interfaces to VLANs

Re: SGE2000 Locks up when adding IPv4 Interfaces to VLANs

Re: SGE2000 Locks up when adding IPv4 Interfaces to VLANs

Re: SGE2000 Locks up when adding IPv4 Interfaces to VLANs

Re: SGE2000 Locks up when adding IPv4 Interfaces to VLANs