Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to configure a 6509 running 12.2(33)SXH4 to load-balance between (2) IDSMs in promiscuous mode. It seems as though as I enter the command "intrusion-detection port-channel 60 capture allowed-vlan " with all the VLANs afterwards, there is...
I am booting a 6509-E with the following boot statements in my config:boot system flash sup-bootdisk:s72033-adventerprisek9_wan-mz.122-33.SXH4.binboot system flash sup-bootdisk:s72033-adventerprisek9_wan-mz.122-33.SXH3a.binConfiguration register is s...
So how do I configure the port-channel group to accept more VLANs? Or can't I? Will I have to use VLAN ranges in the command? This will include VLANs that I am not even using.
I am not so sure about that explanation, because if you look at my "Boot var" line, both files have the ",1;" after it and they are both on the same media. I have also seen a ",12;" listed after a file name
