Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hi,i would like to express my issue and if you are able to advice me . i have a company router IR1101 with internet connection provided with private ipv4 address in the WAN interface. my company uses DMVPN in order to connect to company infrastructu...
Hi,i received an cisco IR1101 i started the router after finding a power supply, and the credentials doesnt work. Did not handle by me all of this time.the reset button doesnt work , i pressed 20 seconds but nothing happend. do you have any suggestio...
hello all,Today i am facing an issue with write memory command. i configured the cisco router from console port and no issue to save the configuration.now i am tryin to save the config via ssh port but nothing happened and seems that is freezed . Sy...
Hello to everyone,Finally i found the root cause of this issue. Customer moder router that is connected to our router , was configured with two subnets,and one subnet was overlapping with an existing VLAN on our Router. Customer remov it and the conn...
Hi, this backup gateway you mean that could be a second ISP ? have found two public IPs , confirmed that they need two internet connections for different purposes.maybe misoconfiguration from customer side on the router that handle Internet connectio...
Attached is all the logs that you requested.apart from the sh run . i can not share it.crypto isakmp keepalive 10 periodic -applied but not resolved the issue or not helpful .sh crypto engine connection active --- is not accepted on this device mayb...
Hi ,you mean todo ping from tunnel10 to the external hub IP?i can ping google from wan interface , and i can pin the external ip hubs! Thanks a lot George!
