Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am having trouble trying to setup VTP on a already configured cisco 2960S. To improve the network consisteny I am trying to configure it as a VTP client for VTP3.I followed the guide at cisco docs to troubleshooting and found that the usual cuplrit...
No change unfortunately:(config)#vtp mode off Setting device to VTP Off mode for VLANS.#delete flash:vlan.dat Delete filename [vlan.dat]? Delete flash:/vlan.dat? [confirm]#vtp mode client Setting device to VTP Client mode for VLANS.#sh vtp status ...
Hi @Georg Pauwen I did that without effect too, I had to set the mode to transparent first because on client mode I couldn't change the VTP version (I could only do the 'no vtp version 3')Still, after the changes, the samb vtp config arised.See inli...
HI @MHM Cisco World I recall doing this at some point where other switches didn't replicate the VLANs from the one I wanted because they had an old configuration. I don't think that this is the issue in this case because if the master was another s...
Yes, it makes no difference:#delete flash:vlan.dat Delete filename [vlan.dat]? Delete flash:/vlan.dat? [confirm]#dir flash:/vlan.dat %Error opening flash:/vlan.dat (No such file or directory)Then trying to trigger vlan.dat clean restore#vtp versio...
