Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Good Afternoon,
I have been using a RV340 router running V1.0.01.17 firmware for a few months and have generally been very happy with the product. I have found it to be big improvement over the RV042G where the load-balancing and protocol binding b...
I have now worked out how to get round this issue.
The problem was that the configuration that I was attempting to load to the second device used a different subnet for the LAN than the default one of 192.168.1.0. This is why the browser was hangin...
I have been struggling with protocol binding on the RV042G and believe that it does not actually work. My device is using Firmware v4.2.3.07. Please see my earlier post.
The choice of WAN ports that are used for traffic also appear to flip erratica...
Thank you for emphasising this, Matthew. The process certainly does take a few minute to complete and it is most important not to interrupt it in anyway until the router re-boots on its own. Otherwise I suspect that you will be back to square one!
I had this problem too with my RV042G, which was just outside the 12 month warranty. However, I did not close the browser window and the process failed when the computer indicated that the router was re-booting.
Cisco could not help and suggested I b...
