Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
BGP advertised and received routes issue
Can someone explain to me what I am missing my configuration given the issues below? I have attached devices mentioned below as well as others in the AS-PATH as well as the section of topology relevant to my i...
I have a similar situation in a simulated but might have resolved. I followed Julio Moisa configurations instructions but I also included the ipv4 address-family for the same neighbor on the XR. The router will bark that it ipv4 unicast and ipv4 labe...
I had similar issue but in my topology I had ISP routers between my firewalls. The DHCP offer was being dropped by Branch Firewall. I saw the advice above to remove the NAT statement and once I did such my PC got its IP assignment. I could the dhcp b...
Harold,I shutdown the interfaces that connect the routers to SW7 to restart theospf process and now I can see the default route on SW7.
*SW7#sh ip route | inc O*E2 E1 - OSPF external type 1, E2 - OSPFexternal type 2O*E2 0.0.0.0/0 <> [110/1] via 10.4....
Hey Harold,So far the rest of the lab is going well except two things which I will tryto figure out the other again on my own but the issue below I cannotresolve.*ISSUE:* SW7 in Office 1 Network is not learning the default routeoriginated by any of i...
Harold,Thanks for your help and explanations as to probable causes. Yes, I mentioned R4 will not need the next-hop-self if this was an eBGP relationship. R23 will not require the next-hop-self cause like you mentioned, its in a different AS so would...
