We just got a Cisco SG300-10P switch in to install at a location within our network (small area, thought it would be better to put them own their own VLAN segment) and this thing is NOT what we anticipated having. Without IOS (and a CLI) we are having a bear of a time getting a correct configuration on this. It is currently set up trunked from a 4506 Switch operating in L2. The 4506 is trunked from a 3750 stack in the data center acting as the core. On each port we would like to do the following so that we can put the data into VLAN1 and the Voice traffic into VLAN 800. By looking at the following IOS config for a port, how does this translate into configuring the SG300 from it's GUI interface? Thanks in advance, Eric switchport mode access switchport voice vlan 800 service-policy output autoqos-voip-policy qos trust device cisco-phone qos trust cos auto qos voip cisco-phone tx-queue 3 priority high shape percent 33 spanning-tree portfast
... View more
