Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,I am facing communication issue between the same security level. I have created two security zones with same security level & i have also configured the command same-security-traffic permit inter-interface & nat-control is disabled by default....
Hi All,I have two firewall's directly connected to the L3 switch & L3 switch have the default route pointed towards one of the firewall & my LAN user's have default gateway as L3 Switch. I woluld like to route some LAN IP's to other firewall. I have ...
Hi All,I have created one L2L VPN between cisco ASA & juniper SRX & VPN tunnel is up. Users of both side are able to ping each other. But the users behind Juniper not able to ping insdie interface of ASA.Thanks
Hi ,I have created the ipsec remote vpn in cisco ASA . The client are able to connect with the firewall & vpn client also received the IP address from the pool assigned in the fiewall, but clients are not able to access the servers behind the ASA & t...
Hi Richard,Thanks for the Reply.If yes i am doing PBR to route some traffic to different route other than default gateway. In my case the switch is Cisco 4503 with supervisor II card installed. Could you please confirm whether PBR using route map is ...
