About isaiasanchez

isaiasanchez · 06-18-2005

I need a sugestion for that... i have a as5350 gw with 4 t1 ports, and i need receive a call directly from an ATA-186 and send it to another gateway by IP. i make a loop in two t1 ports configured as e&m-fgb but it doesn't work. How i must configure ...

isaiasanchez · 06-21-2005

Now i can make calls and the loop is working fine, but the second ATA don't send me rimback, i hear a sound like a Fax machine and in debug q931 the call is normally connected. What can i do now? maybe de AS5350 is not dialing the E.164 number to ATA...

isaiasanchez · 06-20-2005

i solve this problem configuring isdn protocol-emulate network in one serial interface.But now the call don't go to second ATA, and debug isdn q931 say the call was normal clearing by TX. I don't know what happen?Somebody can help me?

isaiasanchez · 06-20-2005

when i configure the T1 as a Isdn-pri i get an error with debug isdn q921:User TX -> SABMEp sapi=0 tei=0User RX -> BAD FRAME (0x00017F)I think this is because Isdn is user side by default in Cisco gw, then how i configure an Isdn pri t1 port as a net...

isaiasanchez · 06-19-2005

I have a same problem, but i don't use CCM. If you read this: http://www.cisco.com/en/US/tech/tk652/tk90/technologies_tech_note09186a0080147524.shtmlyou can understand that the call can't stay on IP network from IP phone to gw A, when the call go to ...

isaiasanchez · 06-18-2005

Config the caller line id network number in the dial-peer, like that:dial-peer voice 123 pots ... clid network-number 9123456 ...And the caller ID will be 9123456

Member Since	‎06-18-2005 08:30 AM
Date Last Visited	‎08-18-2017 03:54 AM
Posts	10

User Statistics

User Activity

Ip to Ip calls

Re: Ip to Ip calls

Re: Ip to Ip calls

Re: Ip to Ip calls

Re: IP phone to gateway to gateway

Re: CISCO 53x0 ISDN screening