We have a multicast source on ACI, the client is reachable via L3OUT.. To make it fonctionnal we have to configure "IGMP Context SSM Translate Policy! Is that normal? the client runs IGMPv3 which is enabled by default on ACI.. Here the cisco doc..Any...

Hi,What can be the raison for non communication between 2 VMs in different Pod but same EPG? the conf on IPN is good and I can see BD multicast IP on IPN Pod1 and Pod2 but using ELAM to capture ARP traffic, I can see it only on Spine Pod1 and not on ...

Hi,Please, what is the difference between :Add new logical interfaces to an existing l3out to an external routerCreate new l3out to the same external router..FYI: will be a new VRF on the external router side.. Thanks,

Hello,I have a fault F1529 on APIC1 which says that "Storage unit /data2 on node 1 with xxx mounted at /data2 is 100% full" !! But when I try to check data2 folder from CLI, I can't find the files that I can delete and the size of data2 folder is onl...

Hi,I just mounted my second pod, everything went well except an error F1425 on one of my spines. I did decommission and regiter but still the same error: two loopback interfaces with the same ip address. Any idea?