Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
I would be performing an upgrade ISE upgrade for a customer.
From 3.0 to 3.4 => which means we have to do a two step upgrade.
They have a small deployment
Primary node => VM
Secondary node => 3615
In order to reduce the time of main...
Hello,
I am preparing for an Upgrade for APIC and I found that APIC has a controllers under unauthorized controllers.
The SN for this entry is the same as the controller 2
Would it be safe to delete this controller? My concern is that as SN is share...
Hello,
I wanted to share the following problem I had while working with a customer:
Cisco Catalyst Center (CC) as a virtual machine, version 2.3.7.7Trying to connect to the Cisco smart licensing server to consume licenses from two virtual smart acco...
Hello,
I was reviewing the following documentation: Firepower Data Path Troubleshooting: Overview - Cisco
In order to troubleshoot packet flow in a ISA-3000-2C2F running 7.2.5 => it is not clear what is the architecture this product is using to prop...
Hello @hamza-ali,
I think you need to be more clear when you said your client is not connecting.
What authentication are you using?
Do you see the client on the WLC at all?
is client not getting an IP Address?
I would advice to attach a full confi...
Question: is the Anchor WLC also added to Catalyst center for assurance?
Anchor will hold the stats for this client, so if you are looking only at foreign side. I don't think you are getting the full picture.
Aaron
Hello @Dustin Anderson .. thank you for your advice.
I also wanted to propose a new IP address for the new VM, but I have heard of problems with IP change in the past, so wanted to avoid this. Now looking at it again, it seems for standalone, it mi...
Here posting the solution for this problem:
To remove the entry you need to run the following command on the 3 APICs.
av.bin sn [node-ID] [SN] erase
To run the above command root access is needed in APIC - so you need to engage TAC so they can give ...
