I have two stand-alone C9500 X16 routers that need to be upgraded from Amsterdam 17.3.3 to Bengaluru 17.6.3. It states that this process requires that both the primary and golden SPI flash devices be upgraded manually and that this can be done either...
I thought it was a fair question having read this. On the C9500-12Q, C9500-16X, C9500-24Q, C9500-40X models of the series, you must manuallyupgrade the ROMMON in the primary SPI flash device, if a new version is applicable, and the releaseyou are upg...
I thought it was a necessary part of upgrading the IOS when a new one is available.I upgraded several other switches where the ROMMON was upgraded automatically.The release notes for the 9500 series and Bengaluru (Pg. 17) state that there is a new RO...
I connected to the console for the upgrade and stayed connected through the reload. The FPGA was upgraded in the process and so was the IOS but the ROMMON was not. I was able to boot the new OS (Bengaluru 17.6.3) but I am still at 17.3.2r when I thin...
Just to be clear. In order to update the ROMMON and successfully install Bengaluru all I need to do is run those two commands before I install the IOS upgrade. I don't have to do anything else to update the ROMMON. I am sorry to ask but I don't unde...
I just want to be sure that when I install Bengaluru 17.6.3 that it will boot correctly. I seemingly would need to at least update the primary SPI. So if I just walk up to the switch and run the upgrade rom-monitor capsule primary switch command it w...
