About Olakunle

Olakunle · 05-04-2025

Hi,At the VMware Workstation 17 player Virtual Machine Network Adapter settings, wether I used Bridged Mode or NAT Mode, the Cisco Modelling Lab 2.6.1+Build 11 is not displaying the ip address to access the CML User Interface. Please kindly help me o...

Olakunle · 11-05-2023

Hi,Previously, I changed the WS-C3750-24PS-S switch console line baud rate to 57600. After I am done using this baud rate, I changed the switch baud rate back to 9600 using the commandsswitch(config)# line console 0 switch(config-line)# speed 9600and...

Olakunle · 11-14-2023

Elliot,According to this cisco websitehttps://www.cisco.com/c/en/us/support/docs/routers/10000-series-routers/50421-config-register-use.htmlthe configuration register for the router if set to 0x3122• Ignores break• Boots into ROM if initial boot fail...

Olakunle · 11-13-2023

Hi Martin,I have finally been able to reset the cisco 3750 switch baud rate to 9600 bps by following Mr Peter Paluch's post athttps://community.cisco.com/t5/switching/3750-recovery-baud-setting/td-p/1869826and also shown below:"The only thing that co...

Member Since	‎09-27-2022 01:20 AM
Date Last Visited	‎05-09-2025 02:31 AM
Posts	4

User Statistics

User Activity

CML 2.6.1 not displaying the IP Address to access the User Interface

Autobaud rate on a cisco switch console line

Re: Autobaud rate on a cisco switch console line

Re: Autobaud rate on a cisco switch console line