Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have setup the Anyconnect towards a ASA with SBL and this works smooth, but I am wondering if there is any way to let the Anyconnect client find out that it is in the office network, and therefor not opening the anyconnect ?Regards,Svein Magne J...
Are you sure that the SFP is a Multimode? It sounds like a singelmode?Cisco GLC-BX-U20 Compatible 1000BASE-BX-U SFP BiDi Transceiver Module (SMF, 1310nm-TX/1490nm-RX, 20km, LC, DOM)And also if you have the BX-U in one end, you need the BX-D in the ot...
According to https://documentation.meraki.com/MS/Deployment_Guides/Getting_started%3A_Cisco_Catalyst_9300_Management_with_Meraki_Dashboard the C9300-NM-2Y is supported, and i also see it in the Port list - but the device is not recognizing the module...
I have been experiencing the same problems the first time after the switch is set to be managed, after bouncing the port the computer is authenticated. So what i now do after adding the switch as managed, I reboot it.
I have not found any way to go around this either, Cisco told me to use the "clean-up agent" on the CAM, but this is not a good solution because i got my PC's located behind IP phones, and therefor i can't bounce the port, and changing VLAN on a comp...
