Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hi,We are trying to convert our Cat OS to Native and we are in the process of converting the configuration. On QoS configuration i am not getting the equelent command in IOS. After searching on Cisco i got one doc which exactly matches with my scenar...
Hi, I would like to know the command for checking the BW utilization of a DS3 link which is terminating on a Catalyst switch port. For this link we have configured the IP and others in MSFC through a VLAN inteface. But sh int vlan "#" is not giving t...
Hi, On my site we are in the proceess of implementing MPLS for sharing the traffic with existing IPLC's and DS3 links. Currently we are running eigrp and sharing the load on all the IPLC's and DS3's. Our challenge is after imlementing MPLS we nee...
Hi All, I would lke to go for multilinking on my links for load balancing. Can anybody confirm me whether it will affect my voice traffic. On my links around 70 % is voice .Thanks.Regards,Jaison
Dear All, I am attaching a scanario, where my destination is A from B and C. It will work fine with eigrp since i am using defaut delay(20000) on all the interfaces and all are 512Kbps pipes. For reaching A , B and C will not take the interconnected ...
Hi , Thanks for your reply and reference. But i use cli to configure the switch not through cisco works . Your point is clear but my question is if i wants to define a vlan based QoS on L2 switch , after defining the policy where do i needs to apply ...
Hi Jack, Thanks for ur reply. I may get the utilization graph if i connect the monitoring system. But i wanted to know only that time utilization only. ie.. if i give "sh int f0/0" on Cisco IOS i can see the utilization at below portion.."5 minute in...
