Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello there!I have 60 AP-1231G units over 8 sites running WDS in conjunction with a WLSE on 2.12FC firmware. A week ago, every AP on every site went into fault mode reporting "802.11b/g Interference Detected". Not matter what I try (rebooting APs, WL...
I have just attempted to use a splitter to power a non 802.3af compliant Wireless Access Point from a POE port on a CE500 switch - the splitter indicates no power and the AP does not power up. It appears that the splitter only accepts power on ethern...
Frank,I have previously downloaded the 2.13.1 update from that link and loaded it into the repository. I can see it there using "Browse Repository" - it just no longer appears (yep, it used to...) once I loaded the WLSE-2.13-CSCse02049 patch... Is th...
Frank,Thanks for the reply! I will attempt the workaround, although I haven't been touching the IDS profiles/settings, it sounds like this is what is going on.I started the upgrade from 2.12FC to 2.13. I then applied the patch WLSE-2.13-CSCse02049. T...
Simon,I'm out of ideas on this one. The debugging for the WLSE part of WDS is very short and needs serious work by Cisco IMHO.Hmm one idea - can you return the access point to defaults and start config from scratch? This worked for a prob I had this ...
Simon,Thanks for your help - I have *finally* been able to resolve this issue. As per your suggestion, I enabled only the two debugs on the WDS AP. I usually enabled a large number more.... The debug read like this when enabling "wlccp wnm":Mar 2 01...
Are there any specific debug methods that helped solve this issue? I have a WLSE running 2.12FCS, 44 1231G's and one subnet out of 4 is not authenticating. I have beat my head against the wall for about a week now. The specific message I am seeing th...
