Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everybody,I have the following configuration for a Remote Access VPN on a PixOS 7.0(2):crypto ipsec transform-set 3des esp-3des esp-sha-hmaccrypto dynamic-map TEST 10 set peer A.B.C.Dcrypto dynamic-map TEST 10 set transform-set 3descrypto map T...
Hi all Forum.I've got a pair of pix515 with a fresh 7.0(4) PIXOS configured in statefull failover configuration with Serial Based failover connection.Looking at the Syslog message i repeatly see message from the standby unit like this:%PIX-3-210007: ...
Hi all.In the Company i work for we use a Complex Device Configuration management system. This system checks also if differences beetween running and startup are present and it versions each startup-configuration in a CVS Data System.After upgrading ...
Hi all.We have got a cisco 2651XM configured to send syslog messages to 3 Syslog Server.The configuration is really minimal :logging trap debugginglogging source-interface loopback0logging SERVER_IP1logging SERVER_IP2logging SERVER_IP3with IOS 12.3.X...
AFAIK this is not possible with a PIX Firewall and PVLAN. This is due to the inside working way of a PIX that never allow a packet entering from an Interface to Exit from the same interface.With Canonical VLAN you will need to configure one logical I...
Each command u give on the Active unit should be "executed" on the Standby unit too by the failover framework otherwise the failover function would not work in case of failure of the primary unit giving u a working device with a different configurati...
If i understood well what u need is to MAP Public Ip Addresses that belongs to the same network of the outside interface Ip Address to some Host in the Inside Interface.All you need in this case are:"static" command to map an address on lower level i...
Working with Debug i've discovered that each time the message appear in syslog the "debug fover fail" on the Standby unit show:Failed to rep un_xlate for np/port/id/3/-1 10.243.65.32/123 - np/port/id/2/-1 10.243.65.135/123 flg: 1000 20 00002The sourc...
Yes my statefull Link is dedicated with a XOver Eth Cable.I've not enabled http statefull, first because i don't know what it is (gonna check it now) second because other pairs of 7.0(x) of PIX works fine as expected in the same configuration of this...
