Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We currently have a Frame relay Network comprised of 80 plus sites running EIGRP. We will be migrating to an MPLS network soon using Juniper Routers. Are there any recommendations on how best to accomplish this??? Any help would be greatly appreciate...
I need to configure PVST+ on a Cisco Catalyst 2950 with IOS Version 12.1(22)EA8a however the available options only shows - Multiple Spanning Tree(MST)and Per Virtual Spanning tree(PVST). Do I need to enable Rapid Spanning Tree?? PLease help.
Does anyone here know how to transfer configs from a sonic firewall appliance to a pix 525 firewall or would point me in the right direction of getting this done. Or do i have to reconfigure the pix firewall from scratch?????
I want to implement a vpn concentrator on our network instead of having the pix as the end point for remote access. Is there an advantage or disadvanage of this solution???? Any advice would be greatly appreciated.
vpn users are connecting using vpn tunnel terminating at a pix 515e however they are unable to use the application connecting over port 3404. It used to work, or so I was told, but it doesn't work anymore. What am I doing wrong??? Please advise. Here...
Since the MPLS network will be using BGP would it be better to enable OSPF on the Cisco Frame routers along side EIGRP and then do some redistribution or would it be better to use static routes?? Is there a best practice design for this scenerio???
Your suggstion was definately on the right path. My access-list 10 which permits 10.0.0.0 network to the 192.168.0.0 had a line that permited 192.168.0.0 to any any; which access-list 10 was applied to the lan to lan config; was directing traffic to ...
According to Cisco my configs are okay. While connected to the tunnel we can ping hosts on network 192.168.0.0 however we cannot ping the server that the application resides on.Or rather, from the firewall we can see that the server replies back but ...
This is the current crypto map config. I'm new to firewalling so I may have missed a step. What would be the correct command line????ysopt connection permit-ipseccrypto ipsec transform-set DYNAset esp-3des esp-md5-hmaccrypto ipsec transform-set To_NH...
we are currently using the pix 515E and we are already using remote vpn. And the remote users are using a vpn client to get access. However my boss is asking is there a more secure method???
