Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everyone,In a remote office, I replaced the rack with 2 new C9200L-48P-4G switches (installed version: Cupertino 17.9.5 (MD), the latest available).We already have many Catalyst 9200 switches in production with this release, but only on this ne...
Hi everyone,I'll make a small introduction, I work for a GDO retail trade in Italy and in recent months we have been implementing the AP of a multinational company for management of electronic labels in our stores.Their access points have strange beh...
Wow! We have over 200 Catalyst 9200 switches in production running Cupertino version 17.9.4 or .5. For the others (running 17.9.X Cupertino and 17.3.X Amsterdam), we are scheduling updates to gradually move them all to 17.9.5.Now, I’m thinking that I...
So I'll answer you in order on all the points:The AP documents I added should be correct, because sent me directly from the manufacturer. I hope..The only doubt that came to me is that the AP, during the classification event (where in this case it re...
No because if I connect the same AP in another port or another switch the problem is the same.. The company that owns the custom APs, told me that the access points have a burnt port and that the fault is the switch, because supplied them with too mu...
