About oliverwood

oliverwood · 07-28-2005

I'm looking for a network device that can perform the following tasks:I currently have a cisco 1721 with 3 ethernet ports (builtin one plus two wics) – maybe it could be done with this ?Translate 6 fixed ip addresses residing (inside) on two differen...

oliverwood · 08-04-2005

I have tried the following config (see attached), but with the vlans the only one that works is vlan 1 the one with native at the end.also included sho vlans as wellif you do a debug ip nat and debug ip packets it does not show anything when you ping...

oliverwood · 08-04-2005

Could you elaborate on the VLAN's please !Can they only be created on the FastEthernet0 port and not the normal WIC-1ENET ports.What would the benefit be on using the VLAN option over the secondary subnet option ?Thnx yet againOlly

oliverwood · 08-03-2005

Seems to have done the trick.On a side, as the router I am testing on is one module short (just fastethernet and one wic-1enet) is it possible to place the two inside subnets:192.168.3 and 192.168.2 onto one physical port on the 1721 ? (ios 12.3).Tha...

oliverwood · 08-03-2005

Other attachments for previous post from myselfI am only using the Fastethernet0 and ethernet0 interfaces to simplyfy things before I add the the ethernet1 (192.168.2) interface and the acl'sCheers again for your helpOlly

oliverwood · 08-03-2005

I have simplified the config to a minimum, see attached config.D1 just loops back when you ping 192.168.3.120, never gets to the NAT stage (see debug info attached)F2 reaches D1 but the return never gets back to F2 (see debug info attached)Also attac...

Member Since	‎07-28-2005 03:33 AM
Date Last Visited	‎08-18-2017 03:54 AM
Posts	8

User Statistics

User Activity

CISCO 1721 And NAT with 3 LANS

Re: CISCO 1721 And NAT with 3 LANS

Re: CISCO 1721 And NAT with 3 LANS

Re: CISCO 1721 And NAT with 3 LANS

Re: CISCO 1721 And NAT with 3 LANS

Re: CISCO 1721 And NAT with 3 LANS