Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
Anyone know is ESA able to revert to the factory AsyncOS version even the version not listed out by the revert command?
As I upgraded the AsyncOS to 9.7.0-125 but I would like to revert to the factory version 7.6.2-014. At the time, the earl...
Hello,
Anyone know is ESA able to revert to the factory AsyncOS version even the version not listed out by the revert command?
As I upgraded the AsyncOS to 9.7.0-125 but I would like to revert to the factory version 7.6.2-014. At the time, the earl...
Hi, I'm upgrading the sensor from 5.4.0 to 5.4.0.2. During the upgrade, the FireSight is unable to manage sensor back. I have checked the sensor version is 5.4.0.1 now. When I try to add sensor from FireSight, it pop-up a dialogue box "Could not esta...
Hello Mathew,
Yes. I upgraded the AsyncOS from 7.6.2 > 8.0.x > 8.5.6 > 9.1.x > 9.7.1 and revert from 9.7.1 > 8.5.6.
I think that the old partition are deleted so that I can't revert to 7.6.2.
I would like to test if I can fall back to the version 7....
Hi exMSW4319 ,
I am sorry that I have created duplicate post. Please refer to below link for further discussion. Thanks.
https://supportforums.cisco.com/discussion/12918731/esa-cannot-rollback-factory-asyncos-version
Regards,
Arthur
Hello Matthew,
You can see below picture only have the 8.5.6 version now. No other choice for me to choose.
However, I think the capacity may be the reason cause the earlier version has been deleted but not sure.
Regards,
Arthur
Hello Mathew,
Thanks for your reply. I found that it can only be rollback to 8.5.6-092 now but the I upgraded from was 7.6.2. Due to some reason I would like to rollback to the factory version 7.6.2.
I'm thinking about is the capacity of storage i...
