Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyone,
Im have used TACACS+ with ACS 5.7.0.13 and often when i try to login on my device the error message is (denied access) even though the credencials are ok, when i try again work properly any sugestion? My ACS have integration with window...
Hello everyone,
My enviroment have the controller model WLC 2500 with software version 8.0.120.0 plus 15 APS model AIR-CAP2702I-Z-K9 here we use 802.1x with ACS.
We have :
good and strong signal
good troughput
But somehow my clients using macbook...
Hello,
Nice post however when i tried to do this on cisco router C887VAG-4G-GA-K9 does not worked and the messages on "terminal monitor" are showed like that bellow:
Jul 15 2016 16:34:34.510 BRST: %CRYPTO-6-IKMP_POLICY_DEFAULT: Using ISAKMP Defau...
Hello all,
I started to study for CCIE and i saw ERSPAN technology however i have onde single doubt...I have to create GRE tunnel before start the configuration or the tunnel will be created automatically? After this CLI bellow:
ASR1002(config)# ...
Yeah i see,
Here we use 802.1x but we have other ssid without 802.1x using only mac-address or ssid default using just password for authentication and we have the same problem somehow the clients lost the connection i dont have any idea about thist p...
