WELCOME to FTD
"Choose one of the topics below to help you on your journey with NGFW/FTD"
Start
Config-examples
Maintenance/Upgrade
Troubleshooting
Tools
Training
Start
Getting Software
Download Softwar...
WELCOME to FXOS
"Choose one of the topics below to help you on your journey with NGFW/FXOS"
Introduction
Start
Config-examples
Maintenance/Upgrade
Troubleshooting
Tools
Training
Start
Getting So...
WELCOME to ASA
"Choose one of the topics below to help you on your journey with NGFW/ASA"
Start
Config-examples
Maintenance/Upgrade
Troubleshooting
Tools
Training
Start
Getting Software
Download Softw...
Hi Rick,
As long as CM has a higher version is good,
Yes, you can have on WAAS environment CM on 6.2.3x and any WAEs on 5.1.x and higher.
So, you can upgrade your CM to 6.2.3 first, and then WAEs from 5.3.3 :
https://www.cisco.com/c/en/us/...
Hi Nabeel,
I don't see any limitations about it.
https://www.cisco.com/c/en/us/td/docs/app_ntwk_services/data_center_app_services/ace_appliances/VA5_3_x/release/note/ACE_app_rn_A53x.html#69806
But to be on a safe side, I would suggest to upgra...
Hi,
Local IP:Port Remote IP:Port Peer ID ConnTypea.b.c.d:51332 e.f.g.h:80 N/A PT In Progress
- That can be with any new connections that just came to the box, as it doesn't have the full TCP-hand...
Hi,
There is no problem, but you would need to check the config to be the same for the device groups, like a class-maps, policy-maps and etc...
What you also could do, is to downgrade the new VCM to the same as previous, register as a Standby,...
Hi Alex,
Before you can register any routers to the CM, I will suggest next steps:
- check if you can ssh to the router from the CM cli by using the same credentials you have specified in the IOS global credentials and/or for that specific device ...