Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
After going through several resources on configuring MAC Authentication Bypass (MAB) with Cisco ISE, I found that it's quite simple. Most of the configuration is done on the switch, with only minimal setup required on ISE for policies and identity ma...
In this lab, I will demonstrate how to configure device administration on Cisco IOS using Cisco ISE and Microsoft Active Directory.Lab topology:Here, Winserver is my AD server and vIOS is my default gateway.PART 1:Joining Cisco ISE with Active Direct...
Hello All, I have purchased a new meraki MX 67 and I have a static IP from the ISP so now when I want to add the static IP, I am connecting my LAN port of MX67 to laptop and proving IP 192.168.128.5/24 and GW 192.168.128.1. While doing DHCP I am gett...
Hello, I want to know how iBGP manipulates OSPF routes to R2 loopback to go via R4 when the link between R1 and R2 goes down.Here I am establishing iBGP neighborship using loopbacks. I have shut down the fa0/0 interface of R1.
Hello, Yes got it, in firewall check the source IP of the ping, Is there any destination NAT configured on your router? As the public IP won't get translated to Private IP and get routed to the servers unless NAT is configured.
As per the network topology, The router's gi0/0/1.60 ip address is 172.16.1.1And in your ACL configuration, you have created the ACE 30 permit ip any any that's why you can ping.What is your WAN IP? 172.16.1.1 or 172.24.60.249
