Hi ChristopheMi,
Without diving too deep on your Azure configuration could be a bit complicated to point the problem but as you said sounds like a routing issue in your Azure (UDR), i will say is probably better to get in touch with Azure so they can...
Hi Matthew Martin,
Check this nice doc from Michael Lorincz out:
https://www.lookingpoint.com/blog/ra-vpn-on-ftd-with-aad-duo-authc-and-ise-authz
That guide seems to point pretty much the same implementation you are trying to do.
Hope this help...
alfo5179,
Seems like there was a problem during the installation of the ASA, you can try performing a complete reimage following this steps:
https://www.cisco.com/c/en/us/td/docs/security/firepower/2100/troubleshoot_fxos/b_2100_CLI_Troubleshoot/b_2...
Hi SAM_2023,
That's a really good point and question, you can actually disable the clientless connection by running one of this options:
1- Keepout
config t
webvpn
keepout "message"
2- Portal Access deny
config t
webvpn
portal-access-rule 1 de...
Hi PeteL,
Can you confirm if you have force re-authentication in the SAML idp config under webvpn?
In theory from the AnyConnect perspective we should not be caching any information when using the embedded browser:
Since Cisco Secure Client with t...