Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a Nexus 9396 and several 2248TP-E Fabric extenders and for some reason, only two are being recognized. The configs are identical, but when I power up each FEX, the FEX shows no link lights on the fiber uplinks and the status light blinks gree...
Configuring a new 3548 switch and can't get the http server to come up. After finally figuring out that the command to enable it is "feature http-server", it shows enabled, but the switch isn't listening on port 80. Strangely, it acts as if the fea...
I beat my against a well trying to add a 3rd AP to my 2504 WLC until I finally saw on the dashboard that only 2 Access points are supported. But when I go look at my licensing, I have a license listingbase-ap-countPermanentNo ExpiryCount 5In use But...
I suppose I can try that, tho it strains credulity that only 8 out of SFPs and cables were good.
I actually was comparing configs all the way through, and discovered that I apparently didn't assign each interface to the port channel, even thought we...
I guess we'll never know if this is true, I'm not buying fabric manager just so I can configure a simple web server for system management. What a ridiculous way to do business. Thanks for the response.
Thank you. I cannot believe that's required, cost me half a day! Would have been nice to at least see it in the logs or in the alerts, or in the AP serial console or.... Jeez, Cisco.
