Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,I would like some help on how to proceed in debugging the issue below for example, what type of logs etc. to collect and analyze. Issue: I have 2802i in mobility express mode with 8.10.185.0 version installed. Another 2702i connects to this ME...
I am trying to setup Passive client on 2802i Mobility Express (v8.10.151.0) so that when I set the bridge mode on vmware for client Windows 10, I directly get the IP from the router. This worked fine on WLC 2504 as per my previous post (Solved: Re: W...
This maybe a very basic question but I wanted to get some insights. Whenever an AP joins a WLC, the WLC has a copy of the AP's Lightweight image and it gets downloaded. In my experience, it doesnt matter what image version is loaded on AP, the WLC wi...
I have home lab setup where I am trying the FlexConnect mode. I am testing this with one AP first so setup is:RVS 4000 router connected to internet.WLC 2504 v8.5.182 connected to RVS4000 LAN port 1AP 2702 connected to LAN Port 2 of RVS4000I am trying...
My setup is:RVS4000 router connected to internet. WLC 2504 v8.5.182.0 connected to LAN port 1 of RVS 4000.Two 2702 APs connected to LAN port 2/3 of RVS 4000 and power via DC adapter.My internet connection maxes out at 350mbps. The device under test i...
The only surprising part is that after executing the commands I mentioned in the previous post, I still see 12mbps set to mandatory. I was expecting only 18mbps as mandatory.(Cisco Controller) >show 802.11b802.11b/g Operational Rates802.11b/g 1M Rate...
Thanks Leo, thanks for sharing this tool. Yes, with the change of making 18mbps as mandatory and disabling 12mbps, I am now getting 30mbps approx in download.
I think I figured it out, I disabled the 12mbps rate and then made 18mbps rate mandatory and that helped me get close to 20-25mbps download. I ran the below commands and that fixed it. config 802.11b disable networkconfig 802.11b 11gSupport enablecon...
Here is the detailed view of channel utilization. As mentioned in the other post, I have small SOC similar to raspberry pie which only has 2.4ghz. I only expect a speed of 10-15mpbs so that it is usable. With speeds of 1mbps download, it is very hard...
Why 2.4 Ghz? What is so unique about this wireless client that it has to use 2.4 Ghz over 5.0 Ghz?What is the channel utilization of the channel being used by this wireless client?I have dragonboard which is similar to raspberry pi and has only 2.4g...
