Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Can anyone point me in the direction of technical documentation that provides DETAIL of the SLB connection sequence ? (Plenty found on configuration examples etc)Having problems getting a pair of 7600 routers to run basic SLB. Real servers show ...
Thanks for the link. I had seen this document. Unfortunately, I am looking for a more detailed explanation of the SLB flow setup and the meaning of the ‘inband_slotmaps: inbound= 0x0180, outbound= 0x0000’. Maybe another job for the sniffer
How about;ip nat pool thuspool-1 prefix-length type match-host so the address used from the pool would match the host part of the source address. IF your addresses lend themselves to this config ?Else you have a lot of statics to configure.
Yes, it works no problem. The only change I had to make was to the time range syntax;time-range early periodic weekdays 6:00 to 18:00!time-range late periodic weekdays 18:00 to 23:59 periodic weekdays 0:00 to 6:00!as the start time must be less tha...
Not sure if the time-range command is still supported, but how about;interface BRI dialer pool-member 1interface dialer 1 dialer string 12345 dialer-group 1 dialer pool 1interface dialer 2 dialer string 987654 dialer-group 2 dialer pool...
