Sometimes, if i add a device to LMS 2.6, it doesnt appear in the DCR straight away, but does show in the "devices not configured in ACS" report. However the devices are in ACS, and after i stop/start dmgtd, the devices appear in the DCR.Obviously i d...

Im just looking into some disaster recovery scenarios, and i have the following questions which i dont seem to be able to find answers to within the documentation.Scenario is a switch was working fine before, and has been backed up with LMS. Its comp...

Hi,Im using LMS primarily for configuration management. We use HP Network Node Manager for fault management. Ive never really looked at DFM as ive always seen it as overlap with NNM. Now, my question is what does DFM provide that NNM cant, or what do...

Ive been playing around with the baseline compliance within RMe on LMS 2.6. First of all, there isnt a lot of decent documentation within the help section IMO. Is there a white paper or some other source of knowledge for these compliance checks ?Seco...

If i create a baseline template using the "Cisco 3800 Series Integrated Services Router" as the device group (the content of the template can be anything, but the same behaviour is apparent), and attempt to run a compliance check, it gives me the fol...