Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a Cisco 1720 with a WIC-1DSU-T1 currently on IOS 12.3(21) running NAT. The T1 is the outside NAT connection on Searial0 and the Fast Ethernet port being inside NAT on FA0. But, I now have some devices I need to put behind this router that ne...
I want to be able to give a server on the network a public routable IP and not a private natted IP. I thought I was on the right track here, but it didn't work. I am obviously missing something.I have the following config:interface FastEthernet0 ip...
I am using a AS5800 with IOS 12.3(16). I have two channelized DS3s coming in for a dialup pool. Every few hours, as little at two, to as much as 48 hours I loose the D channels on the T1s on the channelized trunks. I have done everything I can th...
I am using a Cisco 804 ISDN router. Unfortunately due to area constraints this is what we have to use. I need this to dial out at router startup. I have dug through config option, this forum, and over Internet and can't find a solution anywhere. I ha...
I perform the ping with the following results.Router#ping 66.178.167.3 source 66.178.174.78Type escape sequence to abort.Sending 5, 100-byte ICMP Echos to 66.178.167.3, timeout is 2 seconds:Packet sent with a source address of 66.178.174.78.....Succe...
Thanks for the response. dialer persistant didn't work because I was only using IOS 12.1. I was however able to get SNTP to set traffic out to bring up the connection. Thank you for the assistance.
