Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am adding a new network 10.102.251.0/25 and for this network i have allow only http & https traffic.I have one access-list 122 mapped to serial port through which internet traffic flows.So how can i modify existing access-list as it is allowing all...
I am testing HSRP, what i am doing is that i am shutting the interface on Access Router(ATM sunb-interface).While entering primary Router through its Secondary Router, it is showing me State Active on Primary one, but it should show me standby.proble...
Hi,Try using this command.It will provide u the detail of protocol,Pkts In,Chars In and Pkts out,Chars Out on all the Vlans and the interfaces.Switch#show interfaces accountingAK
Direction is out and i also want to apply out for the new network.If i add network 10.102.251.0 before the last statement.it will not work, what i am guessing.
This is my exisiting access-list.access-list 122 deny tcp any any eq 1025access-list 122 deny tcp any any eq 2967access-list 122 permit ip any anyI want to permit http traffic for this network 10.102.251.0/25.So how can i combine them.
Yes, you need to include network(Vlan1), Network(Vlan2)and loopback under Ospf.Also you need to configure default gateway as the ip address configured under Vlan1 or Vlan2 on your LAN workstations depending upon the Vlan to which they belong.Now you ...
