Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Could you please give me some advice on ways to improve the layout of my network? I currently have the following equipmentRouterCisco 2821Switches29502950Switches in Stack3750G37503750I've purchased two 2960 gigabit switches to replace the two 10/100...
I have one central server that will be tied into a switch with about 24 other server. I need to push large 200 GB+ video files from this central server out to all the other servers. We are ok with 10/100/1000 ports, we have plenty of time to move the...
I'm trying to allow UDP SIP traffic from an inside host to an outside IP. Here is what the results look like with a packet tracer.TCP SIPHere is what the results look like when I tryUDP SIPWhat is happening with the UDP packet?
I need advice with my network setup mainly in regards to VLANS. I have three vlans setup on L2 switches (2950s). The servers that need to communicate between vlans have nic connections going to multiple vlans. I'm in the process of deciding on what s...
I just upgraded my cisco asa 5510 from 8.2.1 to 8.4.1. Now my VPN is no longer working. I can connect to it but can connect to anything from there. The heard the asa creates a log from the upgrade to show me what part of the config doesn't carry over...
Thanks you have been a lot of help. Right now i'm using VTP with one trunk port on each switch. Is only one trunk port the correct way of setting up my vlans? Should I have a seperate trunk port for each vlan?
Thanks for the input. Would adding only one 3560 to my current setup of 2950s limit my capabilities of inter-vlaning? Opposed to replacing all of the switches with 3560s?
Thanks, this is what I foundINFO: MIGRATION - Saving the startup errors to file 'flash:upgrade_startup_errors_201105041246.log' Reading from flash... !!!! REAL IP MIGRATION: WARNING In this version access-lists used in 'access-group', 'class-map',...
I found this in the change log for the version above my current versionSIP Inspection Doesn't NAT Call-info field in SIP Notify messageLooks like I need to upgrade. Thanks, guys.
