Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Cisco Prime Infrastructure rollback same archive configuration for a ASR 1004 to four different ASR 1004 devices. Causing a network outage. Was able to do a comparison of configurations in archive for each device to restore correct configurations. ...
I am running 4.1(4) on my CSM. I know 4.2 supports the sticky header command, but at this time I cannot upgrade to 4.2. How can I do sticky based on header information using 4.1(4). Would I have to do some type of policy? Can you provide an examp...
Can someone tell me the difference in operation of this sticky rule: "sticky 5 netmask 255.255.255.255 timeout 60" vs. "sticky 4 netmask 255.255.255.255 address source/destination timeout 60"? What is the first rule actually sticking on?Thanks,LB
To see the configuration information for "absolute-timeout" command run the following:
show run all | beg "line vty"
you should see the "absolute-timeout set to 0 which is the default.
The reason your were not see it is because you did not include "a...
