Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello:I'm having problems getting a 861 router on line through a cable broadband connection with 1 static ip address. I have been able to NAT the internal and external ip and get on line but I don't think that this is proper. Another issue is that ...
Hi;Regrets up front for such a basic question but I'm new to the Cisco community. I recently purchased an 861 router andI need to forward inbound HTTP requests from my public IP address to an address (web server) inside. I configured an Fortigate 5...
John: This was copied "select all" from the CLI.if it's incomplete as well,perhaps that's a hint of what's wrong in possibly a defective unit. I didhave problems getting the next hop address to "stick" after configuration:it was fine until I powered...
Hi John: Below is the config.I have to tell you that, honestly, I'm stronglyconsidering just going back to my Fortinet for this. Port forwarding can bedone reliably in less than 5 minutes. If you want to have a go at it, I'll do it. Thanks for your ...
Hi John: First, thank you for your reply. Here is what I got when merging your NATcommands : The Cisco IOS returned the following messages when attempting to merge yourchanges to the configuration. Destination filename ? % similar static entry (172...
Hi Rick - I did remove NAT from this config thinking that I first needed to get connectivity through the default route alone.Regarding the NAT situation to the web server (the web server is to a standalone http server for security cameras) I was usin...
