I have a juniper ex4300 configured with a bunch of vlans on an AE interface. connected to this I have a cisco 3750 switch.the link AE to PC is setup with LACP. On the production cisco the link never comes up. neither the pc nor the gigE interface.The...

Hi Folks   I'm attempting to use some cisco 3560CX units attached to a juniper poe ++ switch which supplies power to the cisco 3560. On the 3560CX I want to attach WAPS and IP phones. say 2 of each. I keep getting insufficient total power and the dev...

Hi FolksI have 2 6509's with fwsm in them. They are xconfigured in active standby failover.... default valuesthe 6500's are OSPF routers also. Everything is redundant HSRP, FWSM etc.when we reboot one of the 6500's it takes approximately 45 seconds f...

Good Morning Folks;Below is the output from the show aaa-servers from my asa5540. Notice the status "failed". When the status is thus (on both aaa servers) noone can login the the VPN on the ASA5540. I've checked the duplex / speed etc on the ports f...

Happy Holidays everyoneI'm in the process of migration from a pix 535 to the FWSM. The pix uses conduits and the FWSM uses ACLs. I've moved the format but have found an issuewith access from the DMZ to the inside interface. Isthere something I'm miss...