Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Have three new products on Test Bench:CT2504 WLC w/ver 8.0.100.01702i LWAPP w/ver 15.3(3) JASG300-28MP Switch w/ver 1.3.7.18 (DHCP configured on switch with Option 43.)(no DNS server available) All three devices can ping each other but thats as far ...
Hello, pre 8.3 I would use the Name Command and static map a public IP to a private IP as follows:name 12.236.93.72 InsideHoststatic (inside,outside) InsideHost 10.11.10.1 netmask 255.255.255.255Post ver8.2 I realize that command has changed to the o...
At my edge I've been using an 1841 as an edge router following by a ASA5505 and then to a L3 3750 Switch. My handoff from the ISP (AT&T) is Metro based ethernet (ME-3400 @ 10Mbps). My edge equipment has been working fine for 1/2 year until we upgrade...
I've been struggling with both the Cisco 1841 router and ASA 5505 in trying to assign public IP's on 2 vlans I'm trying to create so both vlans can be segmented but have controled traffic between each other via ACL's. The CLI on both the 1841 and th...
Ok,up and running. Rasika was right. There is bug in 8.0.100.0. concerning the new 1700 series AP's. Got 8.0.100.6 from TAC and the "Discovery" process worked. System running. Thank you all for input.
Thanks Rasiki, I opened a case today. Going over the compatibility documents I also noticed that the 1702i LWAPP software I am running, 15.3(3)JA, may need to be upgraded to the current 15.3(3)JAB.All the configuration / reference material for the 17...
Thank You. This has been quite an educational experience. I am only CCNA, and this vlan database was not covered in my studies. Thank you again. This item is fully resolved.
