About anthonyk72

anthonyk72 · 06-06-2024

Good afternoon,I have a question that is driving me crazy trying to understand.In a 2960 switch, I have the following configuration:VLAN 100 - IP 10.0.100.1 (mngmt vlan)VLAN 1 - no ip addressDefault gateway - 192.168.1.1 (VLAN1)And it works fine.In a...

anthonyk72 · 06-06-2024

Ok, guess i found my answer, on C2960 by default ip proxy-arp is active, but not in the C9200, gone make some tests to see if this theory is correct

anthonyk72 · 06-06-2024

i Use the VLAN 100 ip, the uplink is connected on port gi0/4 (trunk with all vlans, the port in the core is with the same conf)interface GigabitEthernet0/4description ==UPLINK CORE==switchport mode trunk

anthonyk72 · 06-06-2024

interface Vlan1no ip addressno ip route-cache!interface Vlan100ip address 10.0.100.121 255.255.255.0no ip route-cache!interface Vlan998no ip addressno ip route-cache!ip default-gateway 192.168.1.1ip http serverip http authentication localip http secu...

anthonyk72 · 06-06-2024

The 2960 doesn't have ip routing as it is a L2 SW

anthonyk72 · 06-06-2024

rigth now on the 9200 i have the gtw on the same vlan as the mngmt so i can access the swbut it was something like this on the 9200Gateway of last resort is 192.168.1.1 to network 0.0.0.0S* 0.0.0.0/0 [0/0] via 192.168.1.110.0.0.0/8 is variably subnet...

Member Since	‎11-14-2022 10:13 AM
Date Last Visited	‎06-11-2024 01:03 AM
Posts	7
Total Helpful Votes Received	1

User Statistics

User Activity

C2960 vs C9200

Re: C2960 vs C9200

Re: C2960 vs C9200

Re: C2960 vs C9200

Re: C2960 vs C9200

Re: C2960 vs C9200