Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a situation where it is desirable to have multiple links from a Cisco router/firewall to a two Check Point firewalls. The Check Point firewalls both have the same encryption domain and they are not clustered. I know for all Check Point firewal...
I have used the "Maximum Hunt Timer" option to attempt to extend the ring time for a set of phones in a broadcast hunt pilot. However irrespective of the time I set it will not ring the phones more than about 3 times. In addition the field does not a...
Running a CUCM BE 6.1 with only a software conference bridge configured. Phones are assigned to the same device pool as the software bridge. Conference among internal calls work fine. However when a conference is attempted with two PSTN calls, both c...
Deployed a CM BE 6.x. Having an inconsistent problem when users access the AA. The problem is when they attempt to dial by extension from the main greeting, ocassionally an error is given indicating that the input was not recognized. However from the...
Initially I had setup four VM ports through the VoiceMail Port Wizard configuration. However I would like to add the remaining ports. The ports have already been added (through the wizard) but are not registered to the CM. Is there any service that n...
Thanks for your reply Herbert. However I do realise that this type of configuration is only supported between Cisco platforms. The configuration also includes a Check Point firewall.
Thanks for the response. Due to some other problems I had in the translation profile, I simply created a voip DP for each incoming number then send that call to the CM. The CM would then do a translation pattern to the extension for the AA.For each o...
