Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,PIX525 upgrade from 6.3(3) to 7.0.5. Upgrade was successful.Inside - security 100, 10.1.1.0/24demo - security 50, 192.168.1.0/24A server in "demo" segment needs to initiate a connection to a server "Inside". In 6.3, I was doing like this which was...
Hi,I have two CSS11506 devices that need to be deployed for load balancing two sets of web servers (A,B) and (C,D). The servers (A,B) and (C,D) are totally independent and load balancing must be between the same set of servers. The set (A,B) is place...
Hi,My organization has a network with many remote sites connected through Layer-2 MPLS.The hub site is a Cisco 6500 and the remote sites are 3550 switches. The MPLS links to the remote sites are of 10Mbps. There is no configuration w.r.t MPLS on the ...
Hi,I have an IDSM2 module that I have reimaged with WS-SVC-IDSM2-K9-sys-1.1-a-5.1-1.bin.gzTo reach the latest signature level on CCO (S224 as of today), do I need to install IPS 5.1(1d) or IPS 5.1(1p1) first?Per my understanding, I do not require any...
Hi,I reimaged my IDSM2 sensor in the following sequence:1. Installed WS-SVC-IDSM2-K9-sys-1.1-a-5.1-1.bin.gz2. Installed IPS-sig-S222-minreq-5.0-5.pkgI am able to launch IDM and work with it. But, I get the following errors when I type "show events" o...
Hi Vibhor,Well, there is a nat 0 applied for the inside..nat (inside) 0 access-list inside_aclBut, this is only for connections initiated from the inside.Also, the following config does not work nat-control static (inside, demo) 192.168.1.10 10.10.1....
Hi Jack,Thanks for the doc. Yes, I read this page. As there is no "match protocol" command, I believe the only way is to go for the "match access-group" command to classify the traffic.I don't understand why you think the "match access-group" is a pr...
