Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Telnet server is not enable in C1000-24P-4G-L switch, I am not able to access the switch over telnet. my switch config as belowBuilding configuration...Current configuration : 4641 bytes!! Last configuration change at 14:06:55 UTC Sat Sep 16 2023!ver...
I have recently purchased C1000-24P-4G-L model switch, but syrotech SFP module is not supporting . how can fix it !!I have also using C1000-24T-4G-L model switch where syrotech SFP module is supporting and working fine.
Can i get knowledge about VTP(virtual trunking protocol) ! actually I want to make a backup uplink in a cisco switch where both uplink will run at a time and uplink through RF and fibre. If fibre will down RF shall autometically active.In that case m...
I have created a DHCP pool in Cisco 9300 switch and installed 22 Access point to using Wifi.But my issue is, 60 user is connected in access point but dhcp pool is getting full. new user unable connect to wifi.
Can u share STP config CLI ! currently my uplink port configurartion is as below and what config i need to add !interface GigabitEthernet9spanning-tree link-type point-to-pointswitchport mode trunk!interface GigabitEthernet10spanning-tree link-type p...
Hello sir,First i breif you above snap, currently I have connected OFC uplink in between SW1 and SW2, RF uplink is not connected but it is keeping as a backup for SW2 as SW2 site is very critical for us.If OFC will goes down I will connect RF uplink ...
