Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Cisco Community!I am having some trouble enabling telephony-service within packet tracer.Here is what I have:2811 RoutertoCO ServertoCell TowerstoMultiple Smart Phones I have been able to connect everything and can ping between the router and smar...
Hi All! I have created a simple network: I can ping from the laptop to the PC and 2811 router, but I cannot ping from the PC to the laptop or wireless router. I have seen in several other posts that mention a limitation or bug in Packet tracer that d...
Hi @2020ucs0095,There are 5 ports on the WRT300N. 1 Internet port and 4 Ethernet ports. When I initially set this up, I was connecting my switch to the internet port. This was not correct and would typically be connected to your ISP (in the real worl...
Hi @NetworkDave,Absolute clutch!!! 2 things to note:Pinging from the PC0 to the Laptop workedI also noticed that you used an ethernet port vs. the Internet port. I think that is the trick.... I added it to my topology and all of my devices can now pi...
Hi @NetworkDave, Just took a look at this and I am not able to ping from the Laptop or the PC. I can ping the GW router. Not sure if this this right, but the file your provided shows that the Wireless router has no static IP address to the Internet p...
Hi @NetworkDave!I created the network shown above based on a project. Connecting 3 networks via gateway routers. You are correct about the wireless router in that it is a segmented section of one larger network. Providing a handful of deceives the ab...
