Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a 2821 router in Germany configured as a H323 gateway and is attached to an ISDN PRI line. The E1 PRI line is configured with primary-net5 ISDN switch type.The problem is that about 5 inbound calls from the German ISDN network arrive with one ...
As I understand it OSPF area 0 and other OSPF areas must have a 'connection' to area 0 in order to construct a consistent ospf database.My question is what technically is a 'connection'? I know that a router that has an interface in area 0 is a conne...
Does the Gi 0/1 interface on the SSM module have to be connected to the network in order to load IPS software updates on it? I have configured the ASA interfaces already.
I believe this long standing issue has finally been solved. I am noticing this a few seconds after the 6th digit is received 'Sending Complete'. Thereafter the call appears to be routed directly to the recipient.
In conjunction with overlap receiving here is my dial peers. Note that I created a new dial-peer at 1003 to catch all. The originals I left in place, but shutdown.dial-peer voice 1001 voip shutdown destination-pattern 52303. progress_ind setup enable...
Ah, I do see the second iteration of 'Called Party Number' with the missing digit.Here is my serial config.interface Serial0/3/0:15 no ip address encapsulation hdlc isdn switch-type primary-net5 isdn overlap-receiving isdn incoming-voice voice no cdp...
Thanks again for the input.I was investigating a lead I received from another engineer. He mentioned using PRIMARY-QSIG switching type instead of PRIMARY-NET5.Any advice about QSIG vs NET5?
